1.Fix the product in a position where the solar panel can be exposed to direct sunlight and the side with the switch button must be faced down.The product can be inserted into the soil by using the ground stakeor be fixed with screws on the wall, fence, etc..

2.Loosen the screws of the connecting ground rod to adjust the angle of the solar panel surfaceso that the solar panel can receive as much sunlight as possible.Then tightenthe screws.

3.Install the water inlet pipewater outlet pipeteesdrippers filter, etc. according to the installation diagram.The watering flow of the product is about 400mL/min(that isthe sum of the water output ofadrippersis400mL/minPeaseseect the number of drippers and the wateringfrequencyaccordinc to your actual water demand of flowers and plants.

4.Press the ON/OFF switch button to turn on/off the product.

5.Press the MODE button to select the watering frequency. For example, the blue indicator light which is in the first position (upper shows 12lower shows 5)it means that the product will water once for 5 minutes each every 12 hours And, each time the MODE keyis pressedthe system willre-time and will water as the first position watering frequency.

6.This product isPut the long-cable probe into the deep water and when the water level is lower than the short-cable probe(that is, a probe is out of the water),the system will automatically alarm (the buzzer sounds2 times perminute) and stop working(stop watering and timing). After refilling the water. the system willcontinue to work as the previous watering program.

7.When the water pump is idling,the system will alarm(The buzzer sounds twice a minute during the day; at night only the indicator light flashes without a beep),and the green indicator light located at the MODE button will flash.The cause of this failure may be that the water pump or the filter is blocked, please clean them; it may also be that there is no water in the water source container please add water.You can unclog the pump byinjecting some warm water into the pump inlet with a syringe(the syringeis not equipped please purchase it separately if it needed).After troubleshooting, please restart the productthe system will perform a watering and re-time.

8. When the power of the system is lowthe red indicator light located at the ON/OFFbutton will flash.After 30 seconds, the red light will be offand the blue gear indicator will also be off. At this timethe system enters the standby state.Later when exposed to sunlight again and the product gets fully charged the system will automatically return tothe working state(the blue light is on). And the system will perform a watering and re-time.